Archive

You are currently browsing the archives for the Ceramic Photo category.

Dec

31

Ancient ceramics in Palace Museum destroyed

By admin



A piece of ancient Chinese ceramics in the Beijing Palace Museum, known as Ge Ware, has been destroyed due to improper handling. Academics were inspecting the pieces when the accident occurred. The Palace Museum’s inspection of the ancient ceramics has now been suspended.

Ge Ware originated in the Song Dynasty, about 800 years ago. Ge Ware represents one of the pinnacles of Chinese porcelain. Only a few hundred pieces remain, all of them priceless. Ge Ware is renowned for the high skill needed to create their distinctive crackling pattern.

Ge Ware destroyed due to improper handling.

Oct

26

How to Install Ceramic Wall Tiles

By admin



Installing ceramic wall tile can sound like a big job if you’ve never done it before, but it’s really not that difficult once you start following directions on how to do it. Maybe you want to retile your bathroom, kitchen, counter top, backsplash or shower. In any case, installing ceramic wall tiles can give the room a whole new look and feel. Here’s how to install ceramic wall tile:

  1. Mark lines on the wall.To start installing ceramic wall tile, first you need to find the center of the wall and ‘dry fit’ your tiles to see if the pattern ends similarly on the edges. Use a pencil to mark vertical and horizontal lines where appropriate. You want the tile size to be consistent as they approach each end point.
  2. Apply the adhesive.Apply the tile adhesive to the wall with the notched trowel, starting in the middle of the wall. Set the tiles into the adhesive and place the spacers in-between each tile as you go. Be sure to give each tile a little twist to ensure a good bond with the adhesive. Cut the tiles as needed to fit on the ends. You can also use sandpaper to smooth out the tile edges if they are sharp after you cut them.
  3. Let it dry.Let the tiles set in the adhesive overnight.
  4. Mix the grout.Remove the tile spacers and mix the grout according to the manufacturer’s directions.
  5. Apply the grout.Using the rubber float, apply the grout at a 45 degree angle. Wipe off excess grout with a wet sponge.
  6. Wipe clean as needed.After about an hour, check for grout haze on the tiles and wipe them clean as needed.
  7. Seal edges with caulk.Seal the edges with caulk (be sure to use a mildew resistant caulk if the tile is in an area where it will get wet).
  8. See the Resources listed below for more tiling ideas.

Sep

29

Alex Land BA(Hons) Ceramic Design

By admin



I am concerned with creating simple solutions to everyday ceramic tableware products with the main inspiration deriving from contemporary architecture exploring form and function in equal parts.

Sep

29

Avis Tonge BA (Hons) Ceramic Design

By admin



The inspiration for this work has come from water – the lack of it in the third world and its waste in the western world. Taps and bottles have become symbols of western excesses. The use of found objects, recycling, has been symbolic of the ingenuity of those of the third world.

Jul

12

The NMMU Ceramic Design

By admin



 ceramic-design.jpg

The NMMU Ceramic Department offers outstanding facilities and a vibrant staff that are constantly involved with current trends and events. The department has a comprehensive Ceramic Design course and a Ceramic Fine Art component.

 

The Ceramic Design Course is geared to equip learners with the necessary techniques and information for starting their own business once they graduate. The course runs over 3 years, and covers clay hand building, slip casting, press moulding, plaster mould making, jiggering, transfer printing, throwing, glaze and kiln technology. At 3rd year level, learners are encouraged to experiment with their own concepts and to formulate new designs that may become the start of their signature range.

The course also touches on the business component of running a small ceramic studio. Learners are given instruction on costing wares, product evaluation, marketing and product design. Furthermore, learners are exposed to direct selling to the public through the department’s Red Earth Clay Project initiative, an “earn and learn” project, which facilitates an in-house gallery.

 

The Ceramic Fine Art component is primarily focused on the conceptual nature of the artwork. The instruction concentrates on the fabrication of the proposed pieces and their installation and purpose.

Jun

9

Long Neck Vase, Large

By admin



Long Neck Vase, Large

long-neck-vase-large.jpg

Height 31cm

Ceramic Crystal Glaze Long Neck Vase, large, available in 2 colours, Blue & Green.

The glaze is beautifully finished in a creamy high gloss, and detailed with a fluid pattern, like droplets of oil spreading out in water or the layers of a crystal.

Each vase comes individually packaged in its own box.

A stylish gift to add an elegant touch to any room.

Detailed Dimensions: Height 31cms

Jun

3

Ceramic vase and plater

By admin



ceramic-vase.jpg
SIZE: Platter 39.5×3.5
Platter 14*2.5*23.5
Platter 16*2.5*27
Platter 18.5*2.5*35
Vase 28.5*11*54
Vase 32*11.5*33.5
Vase 26*10*44.5
Decription: Ceramic vase and plater; Ceramic reactive glaze vase and plater
Porcelain vase and plater; Ceramic reactive glaze vase and plater
Ceramic flower vase and plater, decorative ceramic vase and plater
For home decoration; Ceramic material
Good price, good control quality
Color should be changed as your specification
We can design as customer’s request
PACKING: Platter 4PCS/CTN
Platter 48PCS/CTN
Platter 32PCS/CTN
Platter 16PCS/CTN
Vase 2PCS/CTN
Vase 4PCS/CTN
Vase 4PCS/CTN
Safe packing ( inner & master carton with 5-ply paper, including the styrofoam, the thickness of styrofoam as per your request of drop test)
Color Box is available
PVC box is available
Payment Terms:
T/T (30%deposit)
Minimum Order:
500 Pieces

Apr

29

Ceramic porcelain products

By admin



 ceramic-porcelain-products.jpg

Ceramic porcelain products:Ceramic flower pot, Ceramic planter, ceramic figurine, porcelain mug, porcelain insulator, ceramic figurine, and industrial ceramic.
Model No:Sc-10017
Material:Ceramic
Sample available.

Packing: Carton or pallet
Model NO.: SC-10017
Trademark: A-oneone
Origin: China
Transportation: By Sea
Export Markets: North America, Southeast Asia, Eastern Asia, Western Europe

Sep

10

A Jingdezhen Potter

By admin



 potter.jpg

Wang Yansheng, a 72-year-old potter, makes biscuit at a workshop in Jingdezhen, east China’s Jiangxi Province, March 22, 2006. Biscuit making is the first main phase of Chinese traditional ceramic making. Jingdezhen, with a history of 1,002 years, is famous for making ceramics for emperors and royal families in ancient China.